Chemistry:Zirconium tungstate

From HandWiki
Zirconium(IV) tungstate
Zirconium(IV) tungstate
Names
Other names
zirconium tungsten oxide
Identifiers
3D model (JSmol)
ChemSpider
EC Number
  • 240-876-3
Properties
Zr(WO4)2
Molar mass 586.92 g/mol
Appearance white powder
Density 5.09 g/cm3, solid
negligible
Hazards
Safety data sheet MSDS
GHS pictograms GHS07: Harmful
GHS Signal word Warning
H315, H319, H335
NFPA 704 (fire diamond)
Flammability code 0: Will not burn. E.g. waterHealth code 2: Intense or continued but not chronic exposure could cause temporary incapacitation or possible residual injury. E.g. chloroformReactivity code 0: Normally stable, even under fire exposure conditions, and is not reactive with water. E.g. liquid nitrogenSpecial hazards (white): no codeNFPA 704 four-colored diamond
0
2
0
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
☒N verify (what is ☑Y☒N ?)
Infobox references

Zirconium tungstate (ZrWO
4
) is the zirconium salt of tungstic acid and has unusual properties. The phase formed at ambient pressure by reaction of ZrO2 and WO3 is a metastable cubic phase, which has negative thermal expansion characteristics, namely it shrinks over a wide range of temperatures when heated.[2] In contrast to most other ceramics exhibiting negative CTE (coefficient of thermal expansion), the CTE of ZrW2O8 is isotropic and has a large negative magnitude (average CTE of -7.2x10−6K−1) over a wide range of temperature (-273 °C to 777 °C).[3] A number of other phases are formed at high pressures.

Cubic phase

Cubic zirconium tungstate (alpha-ZrW2O8), one of the several known phases of zirconium tungstate (ZrW2O8) is perhaps one of the most studied materials to exhibit negative thermal expansion. It has been shown to contract continuously over a previously unprecedented temperature range of 0.3 to 1050 K (at higher temperatures the material decomposes). Since the structure is cubic, as described below, the thermal contraction is isotropic - equal in all directions. There is much ongoing research attempting to elucidate why the material exhibits such dramatic negative thermal expansion.[citation needed]

This phase is thermodynamically unstable at room temperature with respect to the binary oxides ZrO2 and WO3, but may be synthesised by heating stoichiometric quantities of these oxides together and then quenching the material by rapidly cooling it from approximately 900 °C to room temperature.

The structure of cubic zirconium tungstate consists of corner-sharing ZrO6 octahedral and WO4 tetrahedral structural units. Its unusual expansion properties are thought to be due to vibrational modes known as Rigid Unit Modes (RUMs), which involve the coupled rotation of the polyhedral units that make up the structure, and lead to contraction.

Detailed crystal structure

An image of the crystal structure of cubic ZrW2O8, showing the corner-sharing octahedral (ZrO6, in green) and tetrahedral (WO4, in red) structural units. An incomplete unit cell is shown so that the positioning of the W2O8 unit along the body diagonal of the unit cell may be seen.

The arrangement of the groups in the structure of cubic ZrW2O8 is analogous to the simple NaCl structure, with ZrO6 octahedra at the Na sites, and W2O8 groups at the Cl sites. The unit cell consists of 44 atoms aligned in a primitive cubic Bravais lattice, with unit cell length 9.15462 Angstroms.

The ZrO6 octahedra are only slightly distorted from a regular conformation, and all oxygen sites in a given octahedron are related by symmetry. The W2O8 unit is made up of two crystallographically distinct WO4 tetrahedra, which are not formally bonded to each other. These two types of tetrahedra differ with respect to the W-O bond lengths and angles. The WO4 tetrahedra are distorted from a regular shape since one oxygen is unconstrained (an atom that is bonded only to the central tungsten (W) atom), and the three other oxygens are each bonded to a zirconium atom (i.e. the corner-sharing of polyhedra).

The structure has P213 space group symmetry at low temperatures. At higher temperatures, a centre of inversion is introduced by the disordering of the orientation of tungstate groups, and the space group above the phase transition temperature (~180C) is Pa[math]\displaystyle{ \bar3 }[/math].

Octahedra and tetrahedra are linked together by sharing an oxygen atom. In the image, note the corner-touching between octahedra and tetrahedra; these are the location of the shared oxygen. The vertices of the tetrahedra and octahedra represent the oxygen, which are spread about the central zirconium and tungsten. Geometrically, the two shapes can "pivot" around these corner-sharing oxygens, without a distortion of the polyhedra themselves. This pivoting is what is thought to lead to the negative thermal expansion, as in certain low frequency normal modes this leads to the contracting 'RUMs' mentioned above.

High pressure forms

At high pressure, zirconium tungstate undergoes a series of phase transitions, first to an amorphous phase, and then to a U3O8-type phase, in which the zirconium and tungsten atoms are disordered.

Zirconium tungstate-copper system[4]

XRD Spectra from Verdon & Dunand (1997).
Proposed reaction mechanism in the HIP process of zirconium tungstate-copper system from Verdon & Dunand (1997).

Through hot-isostatically pressing (HIP) a ZrW2O8-Cu composite (system) can be realized. Work done by C. Verdon and D.C. Dunand in 1997 used similarly sized zirconium tungstate and copper powder in a low carbon steel can coated with Cu, and they were HIPed under 103MPa pressure for 3 hours at 600 °C. A control experiment was also conducted, with only a heat treatment (i.e., no pressing) for the same powder mixture also under 600 °C for 3 hours in a quartz tube gettered with titanium.

The results from X-ray diffraction (XRD) in the graph in Verdon & Dunand's paper shows expected products. (a) is from the as received zirconium tungstate powder, (b) is the result from the control experiment , and (c) is the ceramic product from the HIP process. Apparently there are new phases formed according to Spectrum (c) with no ZrW2O8 left. While for the control experiment only partial amount of ZrW2O8 was decomposed.

While complex oxides containing Cu, Zr, and W were believed to be created, selected area diffraction (SAD) of the ceramic product has proven the existence of Cu2O as precipitates after reaction. A model consisted of two concurrent processes were surmised (as presented): (b) the decomposition of the ceramic and loss of oxygen under low oxygen partial pressure at high temperature leads to Cu2O formation; (c) copper diffuses into the ceramic and forms new oxides that absorb some oxygen upon cooling.

Since only very few oxides, those of noble metals which are very expensive, are less stable than Cu2O and Cu2O was believed to be more stable than ZrW2O8, kinetic control of the reaction must be taken into account. For example, reducing reaction time and temperature helps alleviate the residual stress caused by different phases of the ceramic during reaction, which could lead to a delamination of the ceramic particles from the matrix and an increase in the CTE.

References

  1. "C&L Inventory". https://echa.europa.eu/information-on-chemicals/cl-inventory-database/-/discli/details/111452. 
  2. Mary, T. A.; J. S. O. Evans; T. Vogt; A. W. Sleight (1996-04-05). "Negative Thermal Expansion from 0.3 to 1050 Kelvin in ZrW2O8". Science 272 (5258): 90–92. doi:10.1126/science.272.5258.90. Bibcode1996Sci...272...90M. http://www.sciencemag.org/cgi/content/abstract/272/5258/90. Retrieved 2008-02-20. 
  3. Sleight, A.W. (1998). "Isotropic Negative Thermal Expansion". Annu. Rev. Mater. Sci. 28: 29–43. doi:10.1146/annurev.matsci.28.1.29. Bibcode1998AnRMS..28...29S. 
  4. C. Verdon and D.C. Dunand, High-Temperature Reactivity in the ZrW2O8-Cu System. Scripta Materialia, 36, No. 9, pp. 1075-1080 (1997).

External links